Friday, 30 October 2009

A couple of Coupling Rods



Another new product to upgrade your Mamod loco! These coupling rods replace the stamped out rods on the Mamod or MSS locomotive. Lasercut from 1.6mm Steel holes drilled and reamed for a running fit on the locomotive crank pins. Adds a little interest to the loco and look particularly good when steel wheelsets are fitted. Supplied in pairs.
Posted by at

2 comments:

  1. Anonymous29 September 2011 at 13:10

    Carbonsteelpipefittings is a manufacturer & exporter of carbon Steel Buttweld Fittings, carbon Steel Elbow, carbon Steel Flanges.It manufactures carbon Steel IBR Flanges, carbon Steel Pipe Fittings.
    carbon Steel A105 Forged Fittings

    ReplyDelete
  2. f.paul9 January 2013 at 04:30

    Hi,,
    If you are still uncertain about this process then its probably a better idea to go down to your local mechanic or car body shop and offer one of the lads 20 pounds to fit the Number platesfor you. It should only take him half an hour and you will probably find that he will supply any new plastic caps or screws that may be required.

    ReplyDelete

Subscribe to: Post Comments (Atom)